01-19-2015 06:25 AM
I have a set of Phillips Hue bulbs, I was thinking of getting a WeMo light switch to control them with IFTTT.
The place where I would put the switch is where the switch currently is to turn on the celing fixture with the Hue bulbs.
The thing I don't understand, and was not able to determine from googling is: is it possible to program the WeMo light switch to NOT cut the power to my lamp when I press the physical button, but just do my programmed action from IFTTT. Because I want the power to always be on to the bulbs, since they can be switched off programmatically and on again.
And in the case of there being no wifi connectivity, to revert to physically turning the lamp on and off, but that's a bonus.
Solved! Go to Solution.
01-21-2015 08:13 PM
It's an odd investment of $40, but you could simply hook up the wemo switch to power and neutral - don't run the fan load through it (tie the black wires together with hot). Leave the physical switch in place too, or wire straight through.
A more versitile solution might be a low end tablet: http://community.wemothat.com/t5/WEMO-Ideas/Wireless-Keypad-for-Local-Use/idc-p/6950#M762
01-23-2015 06:15 AM
I'm sorry I don't really understand electrical stuff very well.
You are saying I can wire the switch such that it gets power but doesn't actually turn off the lamp? I'll read up on this.
I don't want to use a tablet really because it's not just for me, I just want to have something as close to a physical light switch as possible.
Do you think I should do this wiring with a WEMO, or I should a switch lock like this:
and a Hue Tap device:
to place next to the switch plate instead? The advantage of this is of course no electrical wiring needed, but a WEMO switch would be more elegant and would be less clutter. The cost is about the same for both solutions.
01-23-2015 11:18 AM
01-23-2015 01:18 PM
What if I use a WeMo python library and a Hue python library to tie these together rather than IFTTT on my computer. Would this be faster and more reasonable than IFTTT for a light switch?
07-06-2015 05:32 PM