04-29-2018 08:16 PM
I'm attempting to install my first WEMO Switch. It's a non-dimmer, just normal switch. I have an older 1950s house with knob and tube wiring and was afraid I wouldn't have a neutral wire. However, I did find a white-capped wire, in addition to the two black wires.
So I hooked it all up, turned on the power and the ceiling light the switch is supposed to control is now continually softly flickering. I switched the two black wires and tried again and the light is still flickering really weakly like it's not drawing enough power. The switch itself works fine and I can see and add the device on the Wemo App.
Any suggestions? I've attached a pic in case the issue is my wiring.
05-26-2018 01:53 AM
@jacksonrabbit Apologies for the late response. For the wiring installation, you may follow the steps provided on this link. http://www.belkin.com/us/support-article?articleNum=8185...Do keep us posted on how it goes.
06-02-2018 08:28 PM