09-03-2018 05:27 AM
I installed the dimmer on a flush mount kitchen light that says it's compatible with LED dimmers. There is light buzz even at full strength, but if you use the dimmer lower, the light buzzes and flashes almostly like a strobe. Also, the light is only slightly dimmed even when turned all the way down. I'm thinking this was too high of a cost for very mediocre function. Unless i'm doing something wrong? I've tried to calibrate it several times.
09-10-2018 04:59 PM
Hi there! Did you experience the buzzing sound right after the initial installation? Try to reboot unit (Turn OFF the connected bulb. Then press and hold the LED bar for 2 to 5 seconds. Release the button when the LED bar is illuminated white.), and see if still doing the same thing. We can also try to hard reset the unit to further isolate the setback. If issue still recurs, please email us at WemoCares@belkin.com along with the following details so we can have our Escalation Engineers run their diagnosis on this matter:
- Full Name
- Phone Number
- Location - City/State
- Community Username
- Link to this Community thread
We'll be looking forward to your email.