04-10-2018 05:14 PM
04-10-2018 05:39 PM - last edited on 04-17-2018 03:21 PM by Zeb_G
Hi, Rudeboy2tone. You can daisy chain two Wemo Light Switches (have one switch give power to the other while both switches control different sets of light independently) by wiring them as explained by MikeP in the thread below. Also, you might want to note the downside of this setup:
04-10-2018 06:00 PM
If by daisy chained you mean they share a common line in (black) wire that's pretty common. Even if you really mean daisy chained it's fine. The important thing is you have both the black line in and neutral (white) available. Just determine which black wire is the power and use that to feed both switches, and feed both into the neutral. Most likely there's 2 more neutrals from the loads that should go into that white bundle. Then hook the switched reds to the black of each load.
Take this as a guideline as there may be some differences but this should be close.
07-04-2018 03:16 PM